Unboxing and the First-Time Use

1 Unboxing and Working Environment

Notice: Before using, check the packaging first. If there is any damage, please contact with the logistics company and the supplier in your area in time. After unpacking, please check the total items according to the item list.

Table 2-2 myCobot Robot Arm [Standard Set]

Items[Standard Set]	-Robotic Arm (myCobot 280 Raspberry Pi) -Product Manual -Power Supply -USB-Type C -HDMI

Operate the robot only for applications that meet the conditions listed in the table below.

Table 2-3 Working Environment and Conditions

Working Environment	Conditions
temperature	-5°C~45°C
Relative humidity	20%~70%
Space Requirements	indoor
Other Environmental Requirements	-Avoid direct sunlight exposure. -Avoid getting dust, oil fume, salt, iron filings, water etc on robot. -Avoid flammable and corrosive liquids and gases. -Avoid shock and vibration, etc. -Avoid strong electromagnetic interference sources.

2 Installation Requirements

myCobot-280 Raspberry Pi robot weights 860g. Due to the fact that the center of gravity will change along with the movement of the robot during utilization, robot is required to be fixed on a solid base at the beginning. A fixed base, or mobile base are both acceptable.

Size of Base Interface

The base fixing holes act as the interface between robot and other bases or planes. The specific hole size is shown in the figure below. There are 4 countersunk holes with a diameter of 4.5 mm, which can be fixed with M4 bolts.

Please make sure that there are corresponding threaded holes on the fixed base before installing.

Before the installation, please confirm:

The environmental condition meets the requirements listed in Section 2.2.1.3.1 above.
The installation position is no smaller than the working range of the robot, and there is enough space for installation, use, maintenance and repair.
Put the base in a suitable position.
Installation-related tools are prepared, such as screws, wrenches, etc.
After confirming the above, please move the robot to the base installation table, adjust the robot position, and align the fixing holes of the robot base with the holes on the base mounting table. After aligning the holes, align the screws with the holes and tighten them.

Notice: When adjusting the position of the robot on the base installation table, do not pushing or pulling the robot directly on the base installation table to avoid scratches. When manually moving the robot, do not applying external force to the fragile parts of the robot body, so as to avoid unnecessary damage to the robot.

For more installation details, scan the code to watch the video:

3 Power on the Robot

Before operation, confirm that you have read Chapter 1 Safety Instructions to ensure safe operation. At the same time, connect the power adapter with the robotic arm, and fix the base of the robotic arm on the table. The connection method is shown in Figure 3-1.

Figure 3-1 Location of the power connector

myCobot must be powered on with an external power supply to provide sufficient power:

Rated voltage: 8-12V
Rated current: 3-5A
Plug Type: DC 5.5mm x 2.1

You cannot just use the Type-C plugged into the M5Stack-basic for power supply. Please use the official power supply to avoid damage to the robotic arm.